Telefonas
Darbo laikas
Pir- Pen 8:00 - 17:00

Šeš - Sek Nedirbame
Adresas
Perkūnkiemio g. 13-91

Vilnius
Gauti pasiūlymą!

MP600

Printer
Technology: Fused Filament Fabrication (FFF)
Build volume (d x h): 0400 mm x 600 mm, cylindric
Motion system: precision linear guideways
Maximum printhead travel speed: 250 mm/s XYZ
accuracy: 6, 6, 5 micron
Ultimate layer resolution: 50 micron
Electronics: 32-bit
Firmware: open-source Repetier-Firmware Remote
monitoring: built-in HD camera Connectivity: USB
2.0 and Ethernet jacks, Wi-Fi Automation ready:
yes (software interfaces)
Chamber
Build chamber: enclosed
Build chamber door: tempered glass
Build chamber illumination: yes
Build chamber temperature: up to 80°C
Build plate
Type: glass plate
Temperature up to 120 °C
Heatup time: 5 min
Filament dryers
Compatibility: “open material” spools up to 1 kg
Spool size (diameter x width): 200 mm x 80 mm

Aprašymas

Power requirements
Installed power: 3000 W Regulatory
compliance
CE, WEEE
Safety
Air filtering: air & active carbon filters
Door safety switch: yes
Overheating protection: yes
Printer size
Dimensions (w x d x h):
710 mm x 730 mm x 1810 mm
Ambient conditions
Operating ambient temperature: 15-35 °C, 10-90 %
RH
Software
Supplied software:
FabControl® (printing, drying profile management
software)
FabControl® Embedded (device control software)
Supported 3D models file format : .stl, .obj, .3mf
Supported print file format: .gcode (up to 150MB)